| Construction | 3/3-way with rotating spoolClosed loop control circuit and metal to metal seal |
| Power supply | 24 V DC +/- 10%, max absorption 1.5 A |
| Controlinput signal | 0-10 V (on request 4...20 mA or +/- 10 V DC) |
| Command method | If the command signal is lower than 50%, the valve establishes a linkbetween inlet 1 with outlet 2. If the setpoint value is higher than 50%, theport 2 is connected with the exhaust 3. |
| Hysteresis Linearity | LRWD2 = 1% / 1% FSLRPD2 = 0,2% / 0,3% FS |
| Response time | ~ 5 ms |
| Operating temperature | 0 ÷ 50°C |
| Mounting position | In any positionN.B.: The optimal distance of the servo valve from the controlledvolume should not exceed 2m. Longer distances will lower the controlperformance. |
| Fluid | Filtered air 5 μm, non-aggressive gases |
| Relative air humidity | Max 90% |
| Supply pressure | -0.9 ÷ 10 bar |
| Leakage | < 1% of max flow rate |
| Electrical connection | M12 connector, 8 pin, male |
| Supplier code | DN ([mm]) | Max. flow-rate (6 Bar ΔP 1 Bar) ([Nl/min]) |
|---|---|---|
| label LRWD2-36-2-A-00 | 6 | 950 |
| label LRWD2-34-2-A-00 | 4 | 690 |
Contact us without obligation by filling in our form, our experts are at your disposal.
We and selected third parties use cookies or similar technologies for technical purposes and, with your consent,
also for other purposes as specified in the .
If you close this banner with a tick or click on "Decline", only technical cookies will be used. If you want to select the
cookies to be installed, click on 'Customise'. If you prefer, you can consent to the use of all cookies, including
cookies other than technical cookies, by clicking on "Accept all". You can change your choice at any time.
English 
Italiano 
